In a message dated 5/2/00 2:44:01 PM Central Daylight Time,
writes:
<< Have you put a scope on the X & Y outputs of the boardset to make sure
you're getting a good signal yet? >>
Hey, I've learned what the X&Y outputs of the boardset are! Used a scope and
the X seems fine, and the Y is just flat. When I override the brightness I
get a dot in the center of the screen, and wiggling all eight of the pots
doesn't move the dot at all. Shouldn't I be getting a line that would move
around when adjusting the pots?
Does anybody have info on where the particular connectors are, like P900 and
P100 so I can check pins?
Thanks, Arthur.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request . Please direct other
** questions, comments, or problems to neil .
