I reflowed these connectors. I'll re-check continuity between the pins.
I tried putting the game into test mode. All that displays is a line across
the middle of the screen like this...
_\___________________________/_
No beeps, no sounds, no indication of failed parts. No pattern that the
manual says should be there.
As I said in a earlier message, the game comes up now and plays. Stuff is
just all over the screen and sounds seem okay.
Does anyone fix these?
Mike Appolo
http://www.appolo.com
----- Original Message -----
From: "Joel Rosenzweig" < >
To: < >
Sent: Monday, September 11, 2000 9:43 AM
Subject: Re: VECTOR: Tech: Battlezone Vectors Everywhere
> >
> > Any other suggestions?
>
> I had similar problems to this and found that the "ribbon cable" used to
> connect the mathbox with the main board was faulty. Of course, like so
many
> of the PCBs with MTA connectors, the pins on the boards sometimes develop
> hairline fractures and need to have their solder reflowed, too. It would
> not hurt to reflow the solder on both boards just in case.
>
> Joel-
>
>
> --------------------------------------------------------------------------
-
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
> ** message body to vectorlist-request . Please direct other
> ** questions, comments, or problems to neil .
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request . Please direct other
** questions, comments, or problems to neil .
