Try swapping the x and y pins on the monitor connector (or try another known good monitor) to verify that this is a monitor problem. It sounds like it could be a problem with the game board.
Jon
At 03:18 PM 10/23/2000 +0000, you wrote:
>have a later model GO5 that i would like
>some help on, the monitor plays in the center
>of the screen approx. 1/4" wide, the full
>height of the screen, but does not go out
>towards the left or right any further than
>the 1/4" path, i have already installed a cap
>kit with transistors and resoldered all the
>head pins, with NO results, the HV unit is
>working, and the spot killer DOES NOT come
>on, and NO FUSES have been blown. Dont notice
>anything out of the ordinary, was wondering if
>someone on the list could help.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request . Please direct other
** questions, comments, or problems to neil .
