Does anyone know what happened to this project? I tried contacting Mark via
e-mail a while back and got no response.
I'm basically after a spare roller, not the entire assembly.
Thanks
> -----Original Message-----
> From:
> [mailto: ]On Behalf Of Mark E Davidson
> Sent: Friday, September 1, 2000 3:59 PM
> To:
> Subject: VECTOR: MH Repro roller project
>
>
> Here is a quick update on the Major Havoc repro roller project. Right
> before my sons surgery, I found enough time to finish the machining work
> on all the repro rollers, Whets left is to install the encoder PC boards
> and encoder wheels and test them all (where did I put those boards?). At
> that point Ill come up with a clever way to distribute them to the
> masses. Figure mid September to wrap this up as Im in the middle of a
> big automation side job that will be done this week. after that Ill be
> in San Jose doing the installation. After its all said and done im free
> to play on these side projects and can get this whole first run behind
> me.
>
> -=Mark=-
>
>
> ------------------------------------------------------------------
> ---------
> ** To UNSUBSCRIBE from vectorlist, send a message with
> "UNSUBSCRIBE" in the
> ** message body to vectorlist-request . Please direct other
> ** questions, comments, or problems to neil .
>
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request . Please direct other
** questions, comments, or problems to neil .
