I think it's easier to modify the neck board by swapping the socket with a
G07.
-jeff
-----Original Message-----
From: chumblespuzz [mailto: ]
Sent: Wednesday, February 07, 2001 6:39 AM
To:
Subject: Re: VECTOR: Trade Tubes
Ok, ok.
I've gotten a lot of replies about this. My original plan was to hack this
into the WG chassis but I thought it would be easier to just swap it.
Perhaps I'll give the hack a try.
What *exactly* is involved? Is it as simple as putting a GO7 nipple on the
end of the tube and plugging it into the 61xx neck board?
Will I need one of Clay's display correctors?
Thanks,
-roy-
----- Original Message -----
From: "chumblespuzz" < >
To: < >
Sent: Tuesday, February 06, 2001 4:53 PM
Subject: VECTOR: Trade Tubes
> With all the recent posts regarding tubes I'll restate my previous, still
> available offer:
>
> I have an 19" Amplifone tube with yoke that I would like to trade for a
> WG6100 tube with yoke. My tube has no burn-in, but it does have a *very*
> minor scratch. It was removed from a working SW upright. The trade tube
must
> be in similar, working condition.
>
> If you have a WG tube/yoke you want to trade, please email me at
> chumblespuzz .
>
> Thanks,
> -roy-
>
>
>
>
> --------------------------------------------------------------------------
-
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
> ** message body to vectorlist-request . Please direct other
> ** questions, comments, or problems to neil .
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request . Please direct other
** questions, comments, or problems to neil .
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request . Please direct other
** questions, comments, or problems to neil .
