Well you had it mostly right. Both you and Andy.
Not 6.3 at the P900 turned out to be a cracked solder joint on the connector.
Also helps to trouble shoot this kind of stuff when you pull your head out and realize your actually working on a 19V2000. Much easier to check the voltages when you have the right pinouts.
Thanks,
David
----- Original Message -----
From:
To:
Sent: Sunday, April 29, 2001 9:13 AM
Subject: Re: VECTOR: Repair guide for G05-802/805?
There is a fuse in the power supply that controls the 6.3 VAC for both the picture tube's heater and also the lamps in the coin door. It can weaken and create a nice voltage drop if it doesn't flat-out open.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request . Please direct other
** questions, comments, or problems to neil .
