I still can't figure out this monitor.
1) I replaced the chip on the deflection board - no luck.
2) I've gone through this whole monitor and checked out all the
voltages. They're all good except three.
Pins 1&2 on P900 of the High voltage unit. Pin 1 should be 2.8VAC and
pin 2 should be 3.5 VAC.
I get a zero reading on the oscilloscope
Pin 10 on the high voltage unit for the Variable Gain control is also 0,
but I figured it's because it's supposed to be (theoretically).
Everything else looks good.
When I power the monitor up (plugged into a working space fury) the high
voltage turns on for a second but then shuts off. I hear no deflection
chatter. No fuses are blowing, no parts are burning up, the. Only
sound I hear is the fan. I even resoldered any pins that *could* be
bad.
I could sure use some ideas at this point.
Matt
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request . Please direct other
** questions, comments, or problems to neil .
