Wire wrap wire works good for this, I believe that is 26 gauge. Only "high"
current area is the CRT heater supply, and I doubt that would be much more than
6/10 of an ampere. 26 gauge should be good for way more than that over such a
short distance.
Bryan Kruzynski wrote:
> I have a WG K6100 monitor with a cracked neck board. What's the
> minimum gauge wire that I should use to jumper over the cracked circuit
> paths on the board?
>
> Thanks.
>
> Bryan Kruzynski
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request . Please direct other
> ** questions, comments, or problems to neil .
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request . Please direct other
** questions, comments, or problems to neil .
