Lewis,
What happens if you put the bad RAM chip back in
the socket?
Thanks,
-Chris
--- Lewis Mills < > wrote:
> Hi all,
> Well, I thought I was making progress... A BZ main
> board that didn't respond
> at all got me to the test mode after replacing a few
> components and
> repairing a broken edge trace. The test told me that
> the 2114 at C2 was bad,
> so I pulled it, put in a socket, and put in a new
> 9114. Now I don't even get
> the test tones. I get one very short tone (so short
> it is barely noticeable,
> but I repeated the test a number of times to be sure
> I wasn't imagining it).
> I checked to be sure that none of the traces were
> broken, and that I was
> getting a good connection from the traces to each of
> the pins on the 9114,
> and everything seems fine there. Any suggestions for
> next steps?
> Thanks again
>
>
---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message
> with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request .
> Please direct other
> ** questions, comments, or problems to
neil .
__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail - only $35
a year! http://personal.mail.yahoo.com/
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request . Please direct other
** questions, comments, or problems to neil .
