In a message dated 6/15/2001 4:08:20 AM Eastern Daylight Time,
writes:
<< 2) I didn't know this until after, but the overvoltage protection pot
(R17) was
turned completely clockwise. I assume it's probably not good to have the
overvoltage protection turned off while fiddling with the brighness and
focus.
Would this be a correct assumption? >>
This is bad. You want to have this pot adjusted to the center when testing
your HV. WinTron should replace your HVT - how long ago did you buy it? They
are usually pretty good about taking care of their customers.
>>3) For a 25" inch monitor, does anyone have a recommendation for the value
of
R6 used with a Wintron? I understand increasing the resistance also allows
you
to increase the KV. The resistor is currently 3.9k.<<
A 2 or 2.2k resistor should do; however you might want to go to a 1 watt
resistor.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request . Please direct other
** questions, comments, or problems to neil .
