In a message dated 10/23/98 9:56:37 AM Eastern Daylight Time,
writes:
<< The roller is 2 1/2" in diameter and 2 1/16" long. The top and bottom
circumferences of the cylinder are slightly beveled. I compared parts to
one of the track balls on my Marble Madness. The opto board is the same
and so are the bearings. I was hoping the roller shafts were the same but
they isn't. They are about 3/8" longer on the roller than the trackball.
>>
Thanks for the specs, Chris! Is the edge bevel on the roller 1/4 of an
inch?
Thanks,
Michael Kelley
