Well.. I replaced the 7815 and the 7915 a couple times and it didn't seem
to help things any. I did notice that there is +25 on the input leg and
not +22.. could that make a difference? Also, I pulled the 7815's and
7915's off other boards. Are these things all the same? Or are there
variations I should worry about? And can I test them when I pull them
off to make sure they are good? It's possible I killed them while
trying to desolder them, but they are made to get real hot, so I doubt
it (and the -15 worked fine after replacing them). So where do I go
from here?
Thanks in advance,
Jon
At 09:27 AM 3/31/99 -0700, you wrote:
>Sounds like the voltage regulator is bad, or it's not getting the correct
>input voltage (this is where the DAC gets it's power from). Find the 7815 on
>your board and make sure it's getting +22 on the input leg. If it is, then
>replace it. Also check your -15 on the 7915 while your at it.
>
>-jeff
