On Fri, 9 Jul 1999, Jon Raiford wrote:
> I was pretty sure there were 2 of these (one for each end)..
> Now I'll have to go down and check.. I would take a picture
> for you, but I left my camera at work. BTW, my roller was
Thanks. Rodger and I seem to think a hardware store might have a
replacement. The manual only shows one. On the other side is a screw
holding the arm for the optical encoder.
> cracking all to hell when I got it and I had to break the corner pieces
> off the case and glue them back on. Is this typical? Or was some
> numb-nuts just trying to screw it on too tight?
Hmm -- Mine's not cracked. It DID have a piece of clear plexiglass added to
the bottom, however, between the light and the housing.
Also has a Wells monitor in it. Whoever changed the monitor left the fan
mounted underneath it. I can't see it doing much good pulling air from the
bottom of the Wells chasis, so that will probably get moved too.
-Chris
==========================================================
Chris Candreva -- -- (914) 967-7816
WestNet Internet Services of Westchester
http://www.westnet.com/
