MK,
> << After reading MK's article, I restored the board to it's
> original condition with these mods in place. I just finished testing it
> and it works! Unfortunately after a couple of minutes the picture
> begins to fade out of focus. Any ideas? >>
>
> Make sure your focus wire is soldered securely to the board, this often
> develops a bad joint. Also, try cleaning the focus pot. Check for any bad
> solder joints around your HVT and focus assembly.
>
> MK
Thanks for the tips! :-) Question: how do I clean the focus pot? Do
I need to remove the sealant on the back side of the focus knob
assembly?
Regards,
Noel
